The DHmini

Length: 11'on deck

Max Width: 36" on the floor, 42" on the rail

Side Height: 8", 15" to the top of the coaming

Weight: 130 lbs

Capacity: 350 lbs of persons/motor/gear

Max HP: 3.5hp

Cost: $2200

The boat will be constructed of Okuome BS 1088 Marine Ply and clear yellow pine while the coaming and grass rails are ash.
Epoxied 6oz fiberglass cloth sheathing the entire exterior of the boat, while the interior will be coated in epoxy and painted.
electrical ( 2 conveniently located auxiliary plugs, bilge pump, running lights, marine tinned wire)
Fused rocker panel control for running lights, 5 interior LEDs , & 750 gph bilge pump
Sealed 12v 7 amp hour battery
Grizzly Grip spray-In bedliner on the floor of cockpit and both compartments, which further waterproofs the interior as well as adding traction and protection from gas & oil. The top of the decking will also be coated with Grizzly Grip for a non slip walking surface.
UHMW keel strips and graphite coated super slick bottom.
Custom aluminum transom bracket/plate that serves to strengthen transom, distribute motor weight and allow the motor to be shimmed to the correct height
2 part marine foam in the fore and aft compartments to provide emergency floatation
Vinyl coated shelving blind doors and movable running seat that also acts as a back rest.
Lock, Stock and Barrell Flat Marine enamel and custom camo paint job.

All boats will be pre-sold (no inventory on hand). A $ 1000 down-payment shall be due up front and the remaining cost shall be due upon delivery/pickup of the boat.

I will accept Mastercard/Visa through Paypal, however there will be a 3% charge to cover the fees associated with Paypal.

I will deliver or meet for a reasonable fee. If you would like to have the boat shipped, I will handle freighting obligations on this end at the buyers expense.

North Carolina Buyers are responsible for 3% sales tax.

The buyer will be responsible for furnishing a trailer (if desired) and motor.

The DHmini

The boat will be constructed of Okuome BS 1088 Marine Ply and clear yellow pine while the coaming and grass rails are ash.

Epoxied 6oz fiberglass cloth sheathing the entire exterior of the boat, while the interior will be coated in epoxy and painted.

electrical ( 2 conveniently located auxiliary plugs, bilge pump, running lights, marine tinned wire)

Fused rocker panel control for running lights, 5 interior LEDs , & 750 gph bilge pump

Sealed 12v 7 amp hour battery

Grizzly Grip spray-In bedliner on the floor of cockpit and both compartments, which further waterproofs the interior as well as adding traction and protection from gas & oil. The top of the decking will also be coated with Grizzly Grip for a non slip walking surface.